How To Remove The Top Of A Whirlpool Washer

The latest information about How To Remove The Top Of A Whirlpool Washer that you need can be found in this article, all of which we have summarized well.

How to Repair Whirlpool Washers | Hunker

Removing the Top of a Whirlpool Washer: A Comprehensive Guide

Faced with a leaky Whirlpool washer, I realized I needed to remove its top to access the inner components. This straightforward task turned into a learning experience. Here’s a comprehensive guide to help you tackle this project confidently.

Before starting, gather your tools: a screwdriver (preferably a Phillips head), a putty knife, and a towel or cloth to protect your floor.

Unplugging and Preparation

Ensure safety by unplugging the washer from the power source and turning off the water supply. Clear the area around the machine for easy access.

Position the towel or cloth under the washer’s front to prevent water from spilling during the process.

Removing the Top Panel

Locate the four screws securing the top panel to the washer’s body. They are typically found on the back of the machine, two on each side.

Using the screwdriver, carefully unscrew these bolts and set them aside. Gently lift the top panel upwards and slide it back about an inch or two to disengage it from the front of the washer.

Detaching the Control Panel

Once the top panel is partially lifted, you’ll see the control panel attached to it by a wire harness. Carefully unplug the harness and set the control panel aside.

Note the position of the wire harness for easy reconnection later.

Removing the Lid Switch

Locate the lid switch, a small black button or lever usually found on the left front side of the washer’s top. Disconnect the wires attached to the switch and gently pull it out.

Be cautious not to damage the wires or the lid switch.

Lifting the Top

With the screws removed, control panel detached, and lid switch disconnected, you can now carefully lift the top of the washer upwards. Avoid lifting it too high to prevent straining the wires or hoses.

Place the top panel on a stable surface for further inspection or repairs.


Reassembly is essentially the reverse of disassembly. Start by aligning the top panel with the washer’s body and sliding it forward until it engages.

Secure the top panel with the four screws you removed earlier. Reconnect the control panel, lid switch, and wire harness. Plug the washer back into the power source and turn on the water supply.

Additional Tips

If the top panel seems stuck, gently tap it with a rubber mallet to loosen it. Avoid using excessive force or sharp objects that could damage the panel.

Consult your washer’s user manual if you encounter any difficulties or have specific model-related questions.

Frequently Asked Questions

Q: Why would I need to remove the top of my Whirlpool washer?
A: Removing the top provides access to the inner components for repairs, such as replacing a leaking water pump or a faulty lid switch.

Q: Are there any safety precautions I should take?
A: Always unplug the washer before starting work and turn off the water supply. Use caution when lifting the top to avoid straining the wires or hoses.

Q: How do I know if the lid switch is faulty?
A: A faulty lid switch may prevent the washer from starting or cause it to stop mid-cycle. You can test the switch with a multimeter or visually inspect it for any visible damage or loose wires.


Congratulations! You have successfully removed the top of your Whirlpool washer. This knowledge empowers you to diagnose and repair common issues, saving time and money. If you have any further questions or encounter any challenges, don’t hesitate to seek advice from a qualified appliance repair technician. Would you like to explore more washer-related topics?

Pin on office interior design

Thank you for reading How To Remove The Top Of A Whirlpool Washer on our site. We hope you find this article beneficial.

You May Also Like